Throat Plate for Kobalt KT1015 Table Saw
From $17.00
Zero clearance or dado and angle-cut throat plate for the Kobalt KT1015 table saw, or get both and be ready for any cut.
- Designed & 3D-printed in Texas
- Ships within the USA
- Secure checkout by Stripe
Details
Throat plates for the Kobalt KT1015 jobsite table saw. I designed these myself and print them in my own shop in Texas. Choose the plate you need above.
Before you order: Please check that the model number on your saw is KT1015 before you order. Always wear eye protection.
Zero clearance plate
You need this if you want cleaner cuts with your table saw. A tight blade slot supports the wood right at the cut, so plywood and veneer don't chip. The plate comes with a removable, replaceable riving knife for safety. The riving knife stands 3/4 inch tall.
The plate attaches securely with a spring-loaded latch. Retract the latch when you install the plate.
First-time setup:
- Lower the saw blade all the way down and install the plate.
- Set the table saw fence on top of the installed plate.
- Put on eye protection, turn on the saw and slowly raise the spinning blade through the plate. This cuts the slot and the riving knife to suit your blade.
The riving knife can be cut away when you raise the blade for deeper cuts, but always raise the blade only as far as needed to cut through the material. Remove the riving knife, or use a different plate, for cuts that don't go all the way through.
Dado and angle-cut plate
You need this if you want to use a dado stack or make angled cuts with your table saw.
Need another part? Latches, lids and other replacement parts can be ordered on request. Get in touch and tell me your saw model.
Kobalt is a trademark of its owner. Taufs Tuff is not affiliated with or endorsed by Kobalt or Lowe's. The name is used only to show which saw this plate fits.
Questions before you buy? Get in touch or call 361-446-0463.